News

Home > News > Content
The Difference Between High-speed Thin-wall Injection Molding Machines And Ordinary Injection Molding Machines
Apr 12, 2018

1. High-speed thin-wall injection molding machine The high-efficiency, high-speed thin-wall injection molding machine adopts a three-axis linkage mode, which is simply a triple circuit. High-speed thin-wall injection molding machine molding process is as follows: Clamping - Injection - cooling - Open (synchronous tray, storage) - gap time. For example, if we use a conventional injection molding machine to mold a product for 10 seconds, and high-speed thin-wall injection molding machines use the principle of three-axis linkage, the molding time of the product is reduced by about 6 seconds. Two small steps were subtracted, but the time was increased by about half.

2, the molding process of the ordinary injection molding machine is the case of clamping - injection - cooling - storage - mold - mold - gap time.

3, high-speed thin-wall injection molding machine is more environmentally friendly, and ordinary injection molding machine is the use of standard pumps, in the electricity, hydraulic oil and noise pollution.

In summary, high-speed thin-wall injection molding machines use oil-electric hybrid type oil pumps and servo motors. The following advantages of the servo hydraulic system: The implementation of the soft-start mold, it will not have an impact on the power network, in order to avoid pollution of voltage and electricity. We can effectively prevent the oil temperature of the injection molding machine from being too high, so it is better to cool it down. And it greatly reduces the replacement rate of hydraulic oil. The servo hydraulic system has a good click and power system gear pump, which not only reduces the machine operation and noise, but also can better improve the working environment. Compared to the general power injection molding machine, the high-speed thin-wall injection molding machine can not only save 60 to 70% of the electricity, but also greatly reduce the cost of the product.




Copyright © Ningbo Rainbow Control Technology Co.,Ltd All Rights Reserved.Tel: +86-574-89057103